Thread

TS 7.51: Typing in the serial again for second start?

About Truespace Archives

These pages are a copy of the official truespace forums prior to their removal somewhere around 2011.

They are retained here for archive purposes only.

TS 7.51: Typing in the serial again for second start? // Bugs

1  |  

Post by Tiles // Jun 13, 2007, 11:05pm

Tiles
Total Posts: 1037
pic
Have installed TS 7.51, and played around with it. Then i closed it. Then i wanted to open it again. And it refused to load, but asked me for the serial again. Why? I have still entered the serial while the install.


A pitfall at this point, which gave me a short headache. When installing the dialogue is as follow:


Name

Company

Serial


But when it asks the second time it is:


Serial

Name

Company


Because i did it again and again i pasted the serial at the bottom line. And it gave me a invalid serial message then ...

Post by Misc // Jun 13, 2007, 11:14pm

Misc
Total Posts: 59
I made a fresh install of 7.51.
The installer accept my serial, name .... .
At the first start of TS I was asked about the SN as Tiles describes, but I get an alert messag even though I type in the correct SN and Name in the requierd fields. The message reads as follows:
"Either the serial number is invalid or you have not entered a name. Pleasy try again."

Post by Misc // Jun 14, 2007, 2:24am

Misc
Total Posts: 59
Ok it was my fault, I typed in the old TS6 serial number, so never mind!


BTW: Very good and fast support from Paul Ashington! Thank you!
Awportals.com is a privately held community resource website dedicated to Active Worlds.
Copyright (c) Mark Randall 2006 - 2024. All Rights Reserved.
Awportals.com   ·   ProLibraries Live   ·   Twitter   ·   LinkedIn