Workspace panel drawing

About Truespace Archives

These pages are a copy of the official truespace forums prior to their removal somewhere around 2011.

They are retained here for archive purposes only.

Workspace panel drawing // New Users

1  |  

Post by jofan // Jan 13, 2009, 12:01am

jofan
Total Posts: 56
Hi All


Could anyone tell me if it is possible to draw 2d profiles in Workspace similar to the Draw panel mode found in Model side?


I have managed to create a flat plane (in Workspace) and then draw on it by 'adding edges' but it appears these must fully extend to the edges of the plane to be effective (ie i cant just draw open ended shapes within the plane)?


Regards, J

Post by Georg // Jan 13, 2009, 2:01am

Georg
Total Posts: 270
pic
The draw panel has not made it to the Workspace side (yet). You will have to do your drawing in the modeler side and then transfer it to ws. The mode of drawing you suggest is rather primitive, accuracy is difficult that way, no Bezier nodes etc. For accurate drawing I would stick to the Model side for the time being.


Georg

Post by jofan // Jan 13, 2009, 2:38am

jofan
Total Posts: 56
Thanks Georg,


I look forward to the next main update to the Workspace side that will hopefully address some of the shortcomings
Awportals.com is a privately held community resource website dedicated to Active Worlds.
Copyright (c) Mark Randall 2006 - 2024. All Rights Reserved.
Awportals.com   ·   ProLibraries Live   ·   Twitter   ·   LinkedIn