New Materials - Bricks

About Truespace Archives

These pages are a copy of the official truespace forums prior to their removal somewhere around 2011.

They are retained here for archive purposes only.

New Materials - Bricks // New Users

1  |  

Post by thescottishbloke // Sep 10, 2008, 9:17pm

thescottishbloke
Total Posts: 56
Hi,


Im trying to apply a brick texture to a model. The bricks go in the correct direction on one of the sides but on the front of the building they dont seem to. Ive tried to select cubic uv projection but it doesnt work. Any suggestions?


Thanks,


:banana:

Post by brotherx // Sep 10, 2008, 10:31pm

brotherx
Total Posts: 538
pic
You'll probably need to use the UV editor to adjust it. There is a great video on this in, I think, in one of the courses. Check out the spirit of the interface course, chapter 12. This will show you how to use the UV editor, in model at least. The workspace UV is a bit different but no so much that you can't follow it.


I was always terrified of the UV editor until I saw this...

Post by brotherx // Sep 10, 2008, 11:30pm

brotherx
Total Posts: 538
pic
oops, sorry. just realised I said spirit course. meant the Getting started with TS6.6 course. sorry.

Post by Steinie // Sep 11, 2008, 1:31am

Steinie
Total Posts: 3667
pic
Graysho did a tutorial with Modeler awhile back and I still think it is excellent. I watch it often just as a refresher. You can apply the same techniques to workSpace side.

http://forums1.caligari.com/truespace/showpost.php?p=24960&postcount=1
Awportals.com is a privately held community resource website dedicated to Active Worlds.
Copyright (c) Mark Randall 2006 - 2024. All Rights Reserved.
Awportals.com   ·   ProLibraries Live   ·   Twitter   ·   LinkedIn