Problems saving drawn circles in tS7 projects

About Truespace Archives

These pages are a copy of the official truespace forums prior to their removal somewhere around 2011.

They are retained here for archive purposes only.

Problems saving drawn circles in tS7 projects // Archive: Tech Forum

1  |  

Post by kujisha // Feb 12, 2006, 5:51pm

kujisha
Total Posts: 50
pic
I was trying to create the base of a archetectural column as nurbs. I drew a few circles of different sizes. Then I saved the project. Then switched back to another project and then switched to the columns project again. Guess what? No circles. Infact, the project was empty. Tried this a few times with the same results. Even saved the scene in the scenes library to see if I could just reload the scene of drawn circles. Same thing. Scene was empty. Is this suppose to be?

Post by stan // Feb 12, 2006, 6:05pm

stan
Total Posts: 1240
pic
try saving each curve in the curve library..ts7 seems to reload a scene with curves intact for me..

Post by SiRender // Feb 18, 2006, 10:32am

SiRender
Total Posts: 38
I don't think scenes get saved automatically even after you "insert" the scene the first time. Could that be what happened. As far as I can tell you have to right click over the scene and use "replace" to save over the last version.


So, is there something to automatically save the scene or remind you that you haven't saved the scene?
Awportals.com is a privately held community resource website dedicated to Active Worlds.
Copyright (c) Mark Randall 2006 - 2024. All Rights Reserved.
Awportals.com   ·   ProLibraries Live   ·   Twitter   ·   LinkedIn