Run Attached BVH Motion on Model Side Without Separation ?

About Truespace Archives

These pages are a copy of the official truespace forums prior to their removal somewhere around 2011.

They are retained here for archive purposes only.

Run Attached BVH Motion on Model Side Without Separation ? // Tech Forum

1  |  

Post by Mr. 3d // May 21, 2009, 2:07am

Mr. 3d
Total Posts: 747
pic
Is there a successful way to approach attaching a BVH motion to a character that will allow it to run the animation without separating the bones from the character in the Model Side ? It would be nice if I could Render out a BVH animation sequence on the Model Side using LightWorks without the bones separating from my character.

Post by Nez // May 21, 2009, 3:37am

Nez
Total Posts: 1102
pic
Not sure but I thought you could render out workspace animations through modelside/lightworks? I seem to remember something in one of TomG's bitesize videos where the animation was set in workspace, crossed the bridge and chose render to file in model-side - but then the animation option was set for workspace... might be worth a look?


And I thought someone else (Frootee?) developed a method of rendering through LW directly from workspace too which may also work for you?

Post by Mr. 3d // May 21, 2009, 3:50am

Mr. 3d
Total Posts: 747
pic
Frootee's workaround sound like my solution !!! THANKS for reminding me Nez !!! I had that Thread saved in my favorites, but I forgot all about it. I've got it saved to my HD now !!!:)
Awportals.com is a privately held community resource website dedicated to Active Worlds.
Copyright (c) Mark Randall 2006 - 2024. All Rights Reserved.
Awportals.com   ·   ProLibraries Live   ·   Twitter   ·   LinkedIn