DX - View, Scene Ground object (Grid)

About Truespace Archives

These pages are a copy of the official truespace forums prior to their removal somewhere around 2011.

They are retained here for archive purposes only.

DX - View, Scene Ground object (Grid) // Tech Forum

1  |  

Post by Leif // Dec 30, 2008, 5:59pm

Leif
Total Posts: 276
pic
The manual, Chapter2 User Interface, page 70, says:

Just place your own grid object (available in the “DX – View, Components” library as “Scene Ground”) into the scene and this grid will override any per-view settings. When the grid is active, it is displayed in preferences as “Workspace –Ground”.


I can get the solid grid to show, but when Wire is selected no grid shows up.

17220


Edit: I have managed to get wire grid(s) to show up. But when I switch one grid back to solid, it disappears again.


This is picture from page 71 in the manual:

17221

Post by Norm // Dec 31, 2008, 5:26am

Norm
Total Posts: 862
pic
Bring in another grid object. If I remember correctly, the first grid you drag into the LE will replace the original .... so I have seen this same scenario you describe and by dragging in another grid, you can set it up as shown. Is a bit strange I admit but not too difficult to deal with.
Hope is helpful. :)

Post by Leif // Dec 31, 2008, 7:28pm

Leif
Total Posts: 276
pic
Hi Norm.

Yes thank you!
Awportals.com is a privately held community resource website dedicated to Active Worlds.
Copyright (c) Mark Randall 2006 - 2021. All Rights Reserved.
Awportals.com   ·   ProLibraries Live   ·   Twitter   ·   LinkedIn