extrude edge in modelside

About Truespace Archives

These pages are a copy of the official truespace forums prior to their removal somewhere around 2011.

They are retained here for archive purposes only.

extrude edge in modelside // Tech Forum

1  |  

Post by rrf // Sep 6, 2008, 8:39am

rrf
Total Posts: 319
I think I've stumbled upon something....(a glitch maybe) make a box in 7.6 Modelside, select top face, bevel(using bevel, 1.349 - angle 45) - select bevel face and bevel again, (at this point it looks like an edge is selected), now the cool part, use the sweep tool and see if it doesn't extrude the edge. If you sweep again it will work, just don't deselect the edge or you will get the 'can't sweep' message. I'm interested if anyone can confirm?




rf

Post by rrf // Sep 6, 2008, 8:56am

rrf
Total Posts: 319
Follow-up on the last post - it seems that there are two edges very close together that just look like it's extruding one edge. If you grab one of the middle edges (from multiple sweeps) you can separate them, giving volume to the 'fake' extruded edge. Pretty cool though, huh?


rf
Awportals.com is a privately held community resource website dedicated to Active Worlds.
Copyright (c) Mark Randall 2006 - 2024. All Rights Reserved.
Awportals.com   ·   ProLibraries Live   ·   Twitter   ·   LinkedIn